Product profile

This product uses modified silicone emulsion, a variety of functional additives, refined water-based environmental protection cover light paint, as the last protective layer of water-based coating, can greatly improve the service life of exterior wall coating.

Product Use

widely used in decoration and protection of concrete or cement exterior walls; suitable for residential, hotels, office buildings, schools, factory works.

Product characteristics

1, has excellent outdoor weather tolerance, light protection and color protection;

2, excellent alkaline resistance, prevent paint film powder and fade;

3, paint film waterproof performance and water resistance brush is good;

4, construction is simple and convenient, excellent adhesion with the substrate, easy maintenance and recoating;

5, water-borne health products, which meet the environmental protection requirements;

6, construction tolerance is high, the decorative effect is lasting.

Product properties

Ingredients: silicone latex paint;

Color and appearance: transparent and normal appearance

Shluster: matte

Table stem time (h/25℃) ≤ 1

Brush resistance: ≥ 20000

Painting consumption: 10-12 ㎡ / L (dry film thickness of 10um) (the actual paint consumption will vary due to wall flatness and construction process;

Recoating time (25℃): over 2 hours (high humidity or low temperature should be extended).

Construction Suggestions

1, Surface Treatment: Before painting, the wall bottom surface must be clean, dry, flat and free of ash.

2, construction tools: paint brush, roller, high pressure gas spraying, sandpaper;

3, construction conditions: construction above 5℃ and relative humidity below 85%;

4, recommended brushing system: primer-mid-paint-cover paint;

5, dilution ratio: a small amount of water (10-20%) can be stirred evenly according to the construction viscosity;

6, once painted brush should not be too thick, if necessary can be painted step by step;

7, The tools shall be cleaned with water immediately after construction.

Storage, Packaging and Management:

Pack: 18kg/ barrel

Storage: stored in 0-35℃, cool and dry place, the remaining coating shall be sealed. If the product is opened and properly stored for 18 months. If the storage indicators meet the technical indicators of our company.

Note:

1, Air circulation shall be maintained during  construction, and the coating shall be kept away from direct sunlight and heat source;

2, To avoid contamination with skin and eyes or inhaling excessive paint mist, please use masks, gloves and other protective equipment;

3, if stained with eyes, immediately clean with a large amount of water, and ask a doctor to treat;

4, places places where children cannot access;

5、This product is a pure water-based and environmentally friendly product, which should avoid organic solvent pollution.