Product profile

This product uses high quality acrylic resin, a variety of functional additives and good weather resistance face filling, refined into water-based environmental protection external wall engineering latex paint.

Product Use

widely used in decoration and protection of concrete or cement exterior walls; suitable for residential, hotels, office buildings, schools, factory works.

Product characteristics

1, has excellent outdoor weather tolerance, light protection and color protection;

2, excellent alkaline resistance, prevent paint film powder and fade;

3, paint film waterproof performance and water resistance brush is good;

4, has strong cover force, simple and convenient construction, excellent adhesion with the substrate, and easy maintenance and recoating;

5, water-borne health products, which meet the environmental protection requirements;

6, construction tolerance is high, the decorative effect is lasting.

Product properties

Ingredients: High-quality acrylic latex paint;

Film color and appearance: white or light color, normal film appearance

Shluster: matte

Pratio: ≥ 0.92

Table stem time (h/25℃) ≤ 1

Brush resistance: ≥ 8000

Painting consumption: 8-9 ㎡ / L (dry film thickness of 30um) (the actual paint consumption will vary due to wall flatness and construction process;

Recoating time (25℃): over 2 hours (high humidity or low temperature should be extended).

Construction Suggestions

1, Surface Treatment: Before painting, the wall surface must be stable, clean, dry, smooth, and ash-free.Wall surface humidity shall be less than 10% (high adhesion drops, film foaming and flowers), PH shall be less than 10.

2, construction tools: paint brush, roller, high pressure gas spraying, sandpaper;

3, construction conditions: construction above 5℃ and relative humidity below 85%;

4, recommended brushing system: external wall anti-alkali closed primer once, face paint 2-3 times;

5, dilution ratio: add a small amount of water (5-10%) according to the construction viscosity;

6, once painted brush should not be too thick, if necessary can be painted step by step;

7, The tools shall be cleaned with water immediately after construction.

Supporting coating system